TR1120 OWNER’S MANUAL IMPORTANT: For maximum effectiveness and safety, please read this owner’s manual before using your BodyCraft treadmil
9 NOTICE : The treadmill should be placed on a level surface. If the treadmill is not level, the belt will continuously track to low side of th
10 WALKING BELT CENTERING The walking belt may occasionally need to be centered. First be certain that the belt is tensioned properly. Start the t
11 WARNING: ALWAYS UNPLUG THE TREADMILL FROM THE ELECTRICAL OUTLET BEFORE CLEANING, LUBRICATING OR SERVICING THE UNIT. CLEANING General cleaning
12 BEFORE STARTING Straddle the belt and stand on the plastic side rails. Place the safety key onto the circle on the overlay and
13 SPEED +: Increases the speed. Pressing once increases the speed 0.1 mph. Pressing and holding for two seconds will increase the speed fas
14 OPERATION INSTRUCTION (PLEASE READ CAREFULLY BEFORE USING): BEFORE STARTING Straddle the belt and stand on the plastic side rail. Place th
15 P1 Manual Program: Press ENTER button to enter this program. SPEED window will flash. Use INCLINE + - or SPEED + - to set the desired sp
16 Engineering Mode With power ON position, press and hold “SPEED –“ button then press “INCLINE +” button to enter the Engineer Mode. PULSE window
17
18
1 1. It is the responsibility of the owner to be sure that all users of this treadmill are informed of all warnings and precautions.
19
20
21
24
25
2 12. Remove the safety key and store it away in a safe place when the treadmill is not in use. Keep the safety key away from children. 13. We
3 STEP 1 Do not move the treadmill out of the box until unit is assembled. Collapse box bottom and lay sides down before assembly.
4 STEP 2 Lift up the upright handlebar, then fasten the screws (C) and washer (D, E) tightly at the bottom of the upright handlebar. (Figure 2)
5 STEP 3 1. Attach the console to the upright by pressing both handlebars down. Place the washers (D) and screws (C) on the handlebar as shown in
6 STEP 4 Attach upright side cap (B) with screws (D) at the bottom of the upright handlebar, and tighten them well. (Figure 4) FIGURE 4
7 FOLDING After assembly is complete, you may fold the machine into the upright position for storage. To fold the machine, raise the deck an
8 *** THE TREADMILL CIRCUIT BREAKER WILL SHUT OFF POWER WHEN THE ELECTRIC CURRENT IS OVERLOADED. A. Pull out the plug from the electrical socket
Kommentare zu diesen Handbüchern